Injector Solenoid Test using Caterpillar ET Software

How to perform: Injector Solenoid Test using ET Software (CAT Engine)?
The purpose of the injector solenoid test is to diagnose injector wiring and injector solenoid functionality.

Connect Caterpillar ET to your Laptop,
-Open Menu: “Diagnostics – Diagnostic Test – Injector Solenoid Test”
Example: CAT Engine – C11

3.1

NOTE: Injector Solenoid Test cannot be performed while the engine is running.

-Click “Power All” and wait the process until complete (Mode: powered), from Cylinder 1 to Cylinder 6.
-On Menu “Test Results”, all the results are OK, indicates that Solenoid Injector still on good condition.

3.2

NOTE:
-This test identifies an open circuit or a short circuit in the circuit for the injector solenoids. The test activates the injector solenoids one at a time while the engine is not running. A good solenoid will create an audible click when the solenoid is activated. Cat ET indicates the status of the solenoid as “OK”, “Open”, or “Short”.

Be the first to comment

Leave a Reply

Your email address will not be published.


*